The BackTrack Mini will not save a new Waypoint if there is insufficient internal memory.If the satellite icon is flashing, the GPS signal is not active. Before creating a new Waypoint, check that the GPS signal is fixed and not flashing. While in the Settings menu, select WAYPOINTS.Waypoints can mark where you are, where you are going, or where you have been. WAYPOINTS – Waypoints are locations you record and store or upload to the device. About: Firmware version, FCC ID, and IC ID
#BUSHNELL BACKTRACK GPS INSTRUCTIONS FULL#
Brightness – Low, Medium, High Note: the longer the backlight stays on, the more battery the backlight will consume.Reset: Do Factory Reset? Yes or No FW Upgrade: See full instructions on.Off, Daily, AWeekday, Weekend2) Time – Set timer by selecting Hour, Minutes and AM/PM * Note: timer does not vibrate or audio sound.Unit: 1) Unit: English (Ft., MPH) or Metric (M., KPH) 2) Temperature: ☏ or ☌ A: DMS (Degrees, Minutes, Seconds), DMM (Degrees, Decimal Minutes), or DD (Degrees)Timer: 1) Frequency Time Zone: Press the Toggle Up/Down buttons to choose your time zone preference and time display format.to choose which option you wish to make changes.Select SETTINGS to adjust the Time, Units, Backlight, Reset, FW Upgrade, and About.Press and hold the SELECT (2) button for 3 seconds to access the menu.The unit will continue searching for a satellite and consume the battery faster than normal. *It is recommended to turn off the unit when going indoors. After the first power-up in a new area, it may take a few minutes to find the satellite signal. The percentage indicates the strength of the satellite signal. Wait for the GPS satellite to connect (10) (Fig. Press and hold POWER (1) until the display comes on. Plug the provided charging cable and charge the unit from any USB port. Fully charge the BackTrack Mini before use.
0 kommentar(er)
